Blue Ox BX88193 - Manual (Page 16)

13 of 18 292-2658 Date 09/06
Installation
This section will explain how to install the Breakaway (included with the Luxor™).
1. Center and attach the Breakaway switch
to a solid part of the chassis (not to any
additionally installed item). Do not
overtighten. Ensure the switch is able to
pivot but does not pivot too freely.
2. Take the red and black wires leading
from the Breakaway switch and route
them through the underside of engine
compartment to the driver’s side firewall.
Secure the wires to non-moving items
through the engine compartment using
wire ties. Note: Keep the wires clear of sharp
edges.
3. Locate a rubber grommet on the firewall to
push the wires through and into the vehicle.
If one is not available, use a ¼” drill bit to
drill through the firewall. Place a rubber
grommet on the new hole to prevent the
wire from stripping later or grounding out.
4. Strip ¼” of insulation from the end of the
wires. Insert the stripped wire end into
the color-coded banana clip (black wire to
black banana clip, red wire to red banana
clip) and tighten the set screw on pin.
Ensure the wire is securely tightened.
Step 1

Ref Qty. Part# Description
No.
Breakaway System (included with Luxor)
1 1 293-1339 Breakaway Switch with Lanyard
2 1 200-0149 S Hook
3 1 101-5822 Cable Adjustor Plate
4 1 294-0840 Banana Clip Black
5 1 294-0839 Banana Clip Red
6 1 62-3486 Replacement Plug
Breakaway System
Description of your product.
The Breakaway system automatically activates the Apollo® to apply the brakes on your towed vehicle in the event
the motorhome seperates from the towed vehicle. This type of emergency system is required by most states and
provinces.
1
2
3
4 5 6