AASTRA 7147a - for MX-ONE EN - Manual (Page 27)

27
System Dependent Phone Setting
Message Waiting Function (MW)
The telephone is equipped with a Message waiting key with a built in LED. If
you have a voice mail box it is possible to get an indication on the telephone
when you have received a new voice mail. Then the LED will be lighted ON
or flashing in blue. The voice mail box can be reached by pressing the MW
button.
Enable the MW function on your telephone
To enable the MW function it is required to make two settings:
I. Set the MW switch to the position that is supported by the telephony
system. Alternatives are: MW-, MW+, HV.
II. You must store the number to the voicemail box in the MW memory of
the telephone.
I) Setting the Message Waiting Switch
The Message Waiting switch (at the back of the phone) is used to select the
appropriate MW mode (HV / + / - ). Please check which MW type the PBX
system supports.
1. Set the MW switch
Note: If the LED is steady active, change the message waiting switch position.
II) Save your voice mail number in the telephone
1. Place the handset on the phone and press [ ]
2. Press [ ] and enter the number to be saved
3. Press [ ] key again to complete saving
4. The “save” successes with confirmation tone