AASTRA 6755i Installation Guide EN - Manual (Page 14)

8 Model 55i IP Phone Installation Guide
Installation and Setup
Installation and Setup
The 55i can be setup to share a network connection with another network
device. Power can be provided by the power adapter (optional
accessory), or by an 802.3af compliant network power source, or with a
PoE inline power injector (optional accessory). It can also be installed on a
desk or mounted on the wall. If your System Administrator has already
setup your phone, please refer to the 55i User Guide for call handling
information or contact to your System Administrator.
Direct or Shared Network Connection
The phone can be set up as a direct network connection to the Ethernet wall
jack or as a shared network connection as a pass-through if connecting a
computer or another network device.
Direct Network Connection
Located at the top of the phone are two fully switched 10/100 Mbps
Ethernet cable ports. The port marked with
LAN is used to connect the
phone to the network, as well as provide power to your phone (if
required). See the section
"Connecting to the Network and to Power" on
page 10 for more information.
Ethernet
Cable
Other Network Devices
Separate
Network
Jack
Network Jack
(if Inline power provided,
do not install the power adapter)
To Network
Power
Adapter
Power Adapter
Connection