EVS MulticamLSM Version 9.00 - March 2008 User's Manual - Manual (Page 59)

EVS Multicam - User Manual Version 9.00
EVS Broadcast Equipment SA – March 2008
50
SD OUT
D-VITC Field to specify if embedded time code has to be inserted in
the output.
The possible values are:
No No new time code inserted in the output.
In (default) Same time code as in the input inserted in
the output.
LTC Time code from the LTC table inserted in
the output.
USER User-defined time code inserted in the
output.
Lines Lines on which the specified time code must be written on the
output.
UserBits Yes/No flag to specify if the user bits have to be included in
the output. The default value is ‘Yes’.
Clean VBI Field in which the use specifies whether the VBI needs to be
cleaned on the output.
The possible values are:
No The VBI is not cleaned in the output.
Always The VBI is always cleaned in the output.
If not OK The VBI is cleaned in the output if it is not
correct (PlayVar mode, vertical split
screen, etc.)
5.2.2 VITC/ANC M
ANAGEMENT IN
HD IN
AND
HD/SD
OUT
In HD, the page is as follows: