EVS XT3 MulticamLSM Version 11.02 - July 2013 Operation Manual - Manual (Page 216)

Key Behavior
• TAKE: this key is operational in ARM mode.
• RECORD: the remote does not beep if the CAM key refers to an empty block.
• RECORD: pressing this key while the current block is recording does not send any
command to the camera.
• CLEAR: this key has no effect.
Cue points management
• When a new ARM/REC command is issued on a block, all its cue points are cleared.
• If the Last Cue command cannot access the desired TC-pre-roll, the player remains
on the current cue point.
• If the Last Cue command refers to a TC that does not exist anymore, the player
jumps to the beginning of the current memory block.
• Cue points can not be marked when working on several memory blocks.
Vision Research Camera
Application Start
At application start, the recording does not start automatically.
Configuration Parameter Values
• Port = RS422 & Protocol = ASCII
• Or Port = Ethernet & Protocol = TCP
• The PGMSpeed parameter value 1000 is available.
Key Behavior
• TAKE: this key is operational in any mode.
• RECORD: the remote beeps if the CAM key refers to an empty block.
• RECORD: pressing this key while the current block is recording clears all memory
blocks and starts recording on the first one.
• CLEAR: press this key to delete the current memory block data.
206 9. Advanced Control Modes
EVS Broadcast Equipment S.A. Issue 11.02.A July 2013