Vitek VT-1252 - Manual (Page 6)

6
ENGLISH
the synthetic and silk fabrics, iron them
back-side.
SETTING THE IRONING TEMPERATURE
• Place the iron on the base (9).
• Insert the power plug into the outlet; the
(6) indication and the water tank back-
light (11) will light up.
• Set the temperature regulator (13) to the
required ironing temperature: “•”, “••”,
“•••” or “max” (depending on the type
of fabric), the (12) indicator will light up
(Pic.3).
• When the sole temperature (15) reaches
the desired temperature value, the (12)
indicator will go out, you can start iron-
ing.
Note: While steam ironing set the tem-
perature t «••», «•••» or «МАХ».
WATER SPRAYER
• You can dampen the fabric by press-
ing the spray button (4) several times
(pic.4).
• Make sure that there is enough water in
the water tank (11).
IRONING
• Place the iron on the base (9).
• Insert the power plug into the outlet; the
(6) indication and the water tank back-
light (11) will light up.
• Set the temperature regulator (13) to the
required ironing temperature: “•”, “••”,
“•••” or “max” (depending on the type
of fabric), the (12) indicator will light up
(Pic.3).
• When the sole temperature (15) reaches
the desired temperature value, the (12)
indicator will go out, you can start iron-
ing.
• After you finish ironing set the (13) regu-
lator to the “min” position.
• Pull the plug out of the socket and let the
iron cool down completely.
STEAM IRONING
For steam ironing set the temperature reg-
ulator to «••», «•••» or «МАХ». The iron
has an anti-drop valve, which stops water
supply, when the sole temperature is too
low it prevents the appearance of drops out
of the sole openings (15). While heating or
cooling down of the sole (15), you will hear
clicks of opening/closing of the anti-drop
valve it means that the valve works nor-
mally.
• Place the iron on the base (9).
• Insert the power plug into the outlet; the
(6) indication and the water tank back-
light (11) will light up.
• Make sure that there is enough water in
the water tank (11), the (10) indication is
not lighting.
• Set the temperature regulator (13) to the
required ironing temperature: “•”, “••”,
“•••” or “max” (depending on the type
of fabric), the (12) indicator will light up
(Pic.3).
• When the sole temperature (15) reaches
the desired temperature value, the (12)
indicator will go out, you can start iron-
ing.
• Turn the steam supply regulator (3) to set
the intensity of steaming, steam will start
outgoing from the openings of the sole
(15).
• After you finish ironing set the (13) regula-
tor to the “min” position and the steam
supply regulator (3) to the left position.
• Pull the plug out of the socket and let the
iron cool down completely.
ATTENTION!
If during the operation steam is not con-
stantly supplied, check whether the tem-
perature regulator (13) is set properly.
ADDITIONAL STEAM RELEASE
Additional steam release function is useful
when ironing folds and can only be used at
high ironing temperatures (when the iron
1252.indd 6 1252.indd 6 16.04.2008 14:51:32 16.04.2008 14:51:32