Longacre 22172 Robic SC-606W Stopwatch - Manual (Page 6)

Page 6 of
7
(1) Countdown Count-up (CdC) Acts as a “Count Up” chronograph with 1/10 second resolution upon
completion of the countdown time.
You may preset times from 1 second up to 24 hours. The time remaining will be displayed within 1/10
second resolution.
SETTING THE COUNTDOWN TIMER
From NORMAL TIME, press “E” twice to enter the Countdown Timer mode. If the “RUN” indicator
appears, press “A” to stop and “B” to reset the timer.
While in the reset position, press “C” to select the countdown mode. The mode will be indicated in the left
side of the upper row of the display. “CdS” for STOP, “Cdr” for REPEAT, and “CdC” for COUNT UP.
After selecting the mode, press and hold “F” for 2-3 seconds. The “SET” indicator appears and the hour
digits begin to flash. Advance the hours by pressing or holding “C”. After setting hours, press “E” tens of
minutes begin flashing. Press or hold “C” to advance tens of minutes.
Repeat this procedure for setting minutes and seconds. Upon completion of setting the preset time, press
“F” to exit the setting procedure. The preset time will appear in both the upper and lower rows of the
display as shown below.
Please note the SC-606 will automatically exit the setting procedure if no pushbuttons are pressed within
two (2) minutes of entering the “SET” mode.
“STOP” Indicator. Timer is stopped
Pre-Set time of 15 minutes 00 seconds
Countdown STOP Mode
1/10 second digit
Tens and Units of Minutes digits
Seconds Digits
OPERATING THE COUNTDOWN TIMER
After the mode is selected and the preset time value has been entered:
Press “A” to start the Countdown Timer. “RUN” indicator appears.
Pre-Set Time of 15 minutes 00
seconds
Countdown STOP Mode
“RUN” Indicator. Timer is active
Time remaining is 47.9
seconds