M&C TechGroup SP2400-H Operator's manual - Manual (Page 19)

2-1.1-ME Gas sampling and gas conditioning technology 19
N O T E !
A preferred mounting position is to have the probe with its sample gas outlet
pointing downwards, although this is not absolutely necessary for perfect
functioning.
 Insert flange seal  (Fig. 6) between sampling flange and probe flange.
 If the heated probe tube type SP30/35 or the ceramic prefilter type V12 is used, then the probe is to
be screwed to their flange  (Fig. 6)(with welded threaded bolt). First insert the flange seal be-
tween the two flanges.
 If the probe connection does not correspond to the standard flange connection DN65 PN6, then the
optionally supplied adapter flange (Fig. 2 and 6) should be mounted to the probe in the same way.
 For high pressure version /HP a flange ist standardmäßig ein Flansch DN50 PN25 vorhanden
 Screw either the probe tube or prefilter  (Fig. 6) with thread G3/4”o directly or using an extension
tube  with the ¾" flat gasket into the ¾" inner thread of the flange of the probe and tighten.
 Insert sample tube or prefilter of the complete probe unit into the connection piece and screw
probe at the connection piece using the screws, spring rings and nuts supplied.