Vitek VT-1253 - Manual (Page 6)

6
ENGLISH
or MAX (depending on the type of fabric),
the (9) indicator will light up (Pic.3).
• When the sole temperature (12) reaches the
desired temperature value, the (9) indicator
will go out, you can start ironing.
Note:
- While steam ironing set the temperature
to steam using zone or “•••” or MAX.
WATER SPRAYER
• You can dampen the fabric by pressing the
spray button (4) several times (pic.4).
• Make sure that there is enough water in the
water tank (11).
IRONING
• Place the iron on the base (8).
• Insert the power plug into the outlet.
• Set the temperature regulator (10) to the re-
quired ironing temperature: “•”, “••”, “•••”
or MAX (depending on the type of fabric),
the (9) indicator will light up (Pic.3).
• When the sole temperature (12) reaches the
desired temperature value, the (9) indicator
will go out, you can start ironing.
• After you finish ironing set the (10) regulator
to the “MIN” position.
• Pull the plug out of the socket and let the
iron cool down completely.
STEAM IRONING
For steam ironing set the temperature regula-
tor to steam using zone or “•••”.
The iron has an anti-drop valve, which stops
water supply, when the sole temperature is
too low it prevents the appearance of drops
out of the sole openings (12). While heating
or cooling down of the sole (12), you will hear
clicks of opening/closing of the anti-drop
valve; it means that the valve works normally.
• Place the iron on the base (8).
• Insert the power plug into the outlet.
• Make sure that there is enough water in the
water tank (11).
• Set the temperature regulator (10) to the
required ironing temperature: to steam us-
ing zone or “•••”, the (9) indicator will light
up (Pic.3).
• When the sole temperature (12) reaches the
desired temperature value, the (9) indicator
will go out, you can start ironing.
• Turn the steam supply regulator (3) to set
the intensity of steaming, steam will start
outgoing from the openings of the sole
(12).
• After you finish ironing set the (10) regulator
to the “MIN” position and the steam supply
regulator (3) to the off position.
• Pull the plug out of the socket and let the
iron cool down completely.
ATTENTION!
If during the operation steam is not constantly
supplied, check whether the temperature
regulator (10) is set properly and whether
there is water in the reservoir.
ADDITIONAL STEAM RELEASE
Additional steam release function is use-
ful when ironing folds and can only be used
at high ironing temperatures (when the iron
temperature regulator (10) is set to “•••” or
MAX).
When the additional steam release button (5)
is pressed, steam will be vigorously released
from the openings in the iron sole (pic.5).
Note:
- In order to avoid leakage of water from
steam openings, press the additional
steam supply button (5) with 4-5 sec.
interval.
VERTICAL STEAMING
For vertical steaming can be used only when
the high temperature mode is used (set the
temperature regulator (10) to “•••” or MAX).
• Hold the iron vertically at the distance 15-
30 cm from the clothes press the additional
steam release button (5) with 4-5 seconds
interval, steam will be released from the
openings in the iron sole (12) (pic. 6).
Important information
• Vertical steaming is not recommended for
synthetic fabrics.
• To avoid melting the fabric, do not touch
1253.indd 6 1253.indd 6 27.05.2010 10:58:51 27.05.2010 10:58:51