Naxa NCD-708 - Manual (Page 36)

-34-
Touch Screen Operation
During conversation in progress,
tune the Volume switch until you reach
the desired volume level.
ADJUST THE VOLUME
Note:
1). Before using the function of the BT
about the unit , please check your
phone’s instruction guide or contact
phone manufacture if you are not sure
if your phone supports the hands-free
BT function .
2). When operating the function of BT
about the unit , you need make
your call-phone and the unit success-
fully for one time. Afterwards, you only
need to take on the power and the
function of BT will work in three
minutes automatically if you want to
operate the function of BT .
3). If you want not to use the function of
the BT about the unit , you can
select the BT OFF .
During talking mode , user can touch
the screen of the “ ” range (or press
the
“PAIR/ ” button on remote control )
to transfer the audio from the unit back
to the mobile phone for privacy reason .
CALL TRANSFER
In BT menu, touch the screen
of “ ” range (or press briefly
“REDIAL/
” button on remote control) .
END/REJECT A CALL
In BT mode, repeatedly the MOD
on the panel to select the
“BT MUSIC”
Mode . The message will display like
following as follows :
PLAY BT MUSIC
ANSWER A CALL
After you hear the ring tone, a incoming
telephone number will display on the
TFT monitor . Touch the screen of “ ”
range to listen or press the
“PAIR/ ”
button shortly on the remote control .
In BT menu, touch “ ” range (or
press longer
“ REDIAL/ ” button on
the remote control the “DIAL LAST CALL
/DIAL OUT NOW ” will display on the
TFT monitor .
REDIAL LAST NUMBER
13800138000 13800138000
call COME IN call COME IN
Note:
the function of resume playback after
pausing or stopping is available only for
some mobile phone
.