Naxa NCA-604 - Manual (Page 5)

4) Attaching the control panel onto the chassis.
A. Align and thrush the bulge of the control panel into the hollow of the chassis.
B. Push the right end of the control panel to the chassis till a click sound is heard.
* How to clean panel connector
Frequent detachment will cause the panel connectors to deteriorate. To minimize
deterioration, periodically wipe the panel connector with a clean/soft/dry cloth .
5) Test to make sure that it works properly.
3. Instal the main unit according to the installation diagram on the next page:
1) Mount the main unit in A/V position in vehicle.
2) Bend tabs of the sliding metal housing where necessary to ensure that
the front part of main unit is fixed;
3) Use a metal strap to fix the rear part of the chassis.
* Uninstalling the main unit:
1) Remove the metal strap from the main unit;
2) Remove the plastic trim frame from the main unit;
3) Insert a key plate into the left and the right side of the main unit and draw the
main unit out of the sliding metal housing.
Bulge
Hollow
Panel Connector
-4-