Naxa NPB-427 - Manual (Page 5)

4
LOADING THE BATTERIES INTO THE REMOTE HANDSET
 Open the battery compartment cover.
 Insert two “AAA” batteries (not included) as indicated inside the battery compartment.
 Close the cover.
KEY FUNCTIONS:
1. CD PLAY/PAUSE BUTTON
2. CD SKIP FORWARD BUTTON
3. CD STOP BUTTON
4. +10 MP3 BUTTON
5. CD SKIP BACKWARD BUTTON
6. -10 MP3 BUTTON
7. PROG./P-MODE BUTTON
8. BATTERY COMPARTMENT
REMOTE CONTROL OPERATION
To operate the unit with the remote control, point the remote
handset at the remote sensor on the front panel and press the
appropriate button on the remote handset.
The remote works best within a range of 6 ~ 7 meters from the
front panel and on an angle of 30 degrees. Bright sunlight or
room light conditions can interfere with the remote control. If
the remote operation is unsatisfactory or stops working entirely,
first try replacing the remote batteries, then try reducing the
room lighting conditions.
USING THE RADIO
TUNING IN RADIO STATIONS
1. Move the FUNCTION switch to RADIO position, the POWER indicator will illuminate.
2. Slide the BAND switch to select the desired wave band: AM, FM, FM ST..
3. Tune to desired station by rotating the TUNING KNOB.
4. Adjust VOLUME CONTROL to desired volume level.
5. Extend TELESCOPIC ANTENNA to its full length if you are listening to FM broadcasting Gently
rock the unit back and forth to get the best reception when you are listening to AM program, or place
the unit in an open location.
Note: The FM STEREO indicator will be on when you are receiving FM stereo program.
6. Turn off the radio by switching the FUNCTION switch to "TAPE" position
USING THE CASSETTE
UNDERSTANDING THE BUTTONS
RECORD - Press to record from the radio or CD/MP3/AUX player.
PLAY - Press to play cassettes.
REWIND - From stop mode, press to rewind the tape toward the beginning.
F.FWD - From stop mode, press to advance the tape toward the end.
STOP/EJ. - Press to stop current tape activity or to open the cassette compartment door when no buttons
are active.
PAUSE - Press to interrupt tape play or record mode. Press the second time to resume tape play or tape
record mode.