Naxa NSM-436 - Manual (Page 10)

9
CONNECTIONS
Speakers
◆
Connect the black wire of the left speaker to the black terminal marked “L-“on the rear of the main
unit .
◆ Connect the white wire of the left speaker to the red terninal marked”L+” on the rear of the main
unit.
◆ Connect the black wire of the right speaker to the black terminal marked “R-“ on the rear of the
main unit .
◆ Connect the white wire of the right speaker to the red terminal marked”R+” on the rear of the main
unit.
Power
This unit runs on AC 120V power .
1. Plug the power cord into an AC wall outlet .
2. To turn the player on , press the POWER button to power on the unit.
Remote Control
◆
Refer to the diagram .Remove the
battery compartment cover located
on the front of the remote control. Insert
2 ×”AA” batteries ,making sure to match
Their polarities (+/-)to the markings on the
Side of the compartmetn .Replace the cover.
◆ To use the remote ,point it at the remote sensor
Of the player . Operate the remote within 15 feet
Of the sensor and at an agle of +/-60 degrees.
◆ Batteries in the remote will last for approximately 6 months under
Normal use. Replace the batteries if the remote control does not work.
Do not mix old with new batteries ,or differents types of batteries.
◆ Remove the batteries from the remote if it will not be used for a long
Period of time.
▲
The battery used in this device may present a fire or chemical burn
if mistreated .Do not recharge ,disassemble ,incinerate ,or heat the battery(-212°F)
Keep battery away from children .