Naxa NSM-436 User Manual

Page 16

Advertising
background image

15

Basic Operation
1. Use a 3.5mm male to male line in cable (included) to connect the Line-out or Headphone out jack

of an audio device to this system Auxiliary Line-In jack.

2. Press POWER to turn the player on .
3. Set the FUNCTION Mode switch to the “AUX” position .
4. Start playback on the external audio device.
◆

You must use the external audio device to control playback.

◆

To avoid distortion, do not set the volume from the external audio device to very high levels.

TROUBLESHOOTING


There is no power to the device .

◆

Ensure that the power cord is securely connected to the unit and the proper wall outler .

◆

Ensure that the voltage selector has been set properly .

There is no sound .
◆

Ensure that the speaker connections are secure and correct .

◆

Try to adjusting the volume .

◆

Ensure that the player is in the proper mode(CD.UDISK,RADIO)

◆

Ensure that headphones are not connected to the unit.

The sound is distorted .
◆

The unit may be positioned too closely to a large appliance (e,g a TV or refrigerator ). If
possibel ,turn the appliance off or move the unit to another location .

◆

Ensure that the raido is in broadcast reception range .

◆

Decrease the volume level .

The remote control doesn’t work.
◆

Ensure that there are no obstacles between the remote and the player.

◆

Point the remote at the remote sensor on the main unit .

◆

Strong light(e.g, direct sunlight ,fluorescent lights , strobe lights )may interfere with the remote
signal .

◆

Ensure that the batteries in the remote control retain a charge and have been installed correctly .

◆

Try replacing the remote’s batteries .

The device does not play .
◆

Moisture may have condensed inside the player .Remove the disc and leave the player on for
1-2hours and then try again .

The USB disk or SD/MMC card doed not play.
◆

Use only USB-MSC device of flash disk drives . USB-MTP devices are not supported .

◆

Ensure that the USB disk or SD/MMC card has been loaded with compatible MP3 or WMA files.

◆

Ensure that the capacity of the SD/MMC card does not exceed 2GB. High- capacity SD
cards(HCSD) are not supported by this player.

◆

DRM-encrypted WMA files are not supported .

The CD will not play.
◆

Ensure that the CD has been loaded with its label facing up .

◆

Ensure that the CD is not damaged , scratched ,or dirty .

◆

Ensure that the CD is an audio CD ,or that it contains compatible MP3 or WMA files .

◆

DRM-encrypted WMA files are not supported .

Advertising