Ohaus Valor 1000 COMPACT FOOD SCALES Manual multi - Manual (Page 11)

OHAUS Valor TM 1000 Series EN-9
5. MAINTENANCE
Caution: before cleaning, turn off the scale, remove the AC adapter.
5.1 Cleaning
The housing may be cleaned with a cloth dampened with a mild detergent if
necessary. Do not use solvents, chemicals, alcohol, ammonia or abrasives to clean
the housing or control panels.
5.2 Troubleshooting
The following table lists common problems and possible causes and remedies. If the
problem persists, contact Ohaus or your authorized dealer.
TABLE 5-1. TROUBLESHOOTING.
Symptom Possible Cause(s) Remedy
Scale will not turn on No power to scale •
Battery power used up
Verify connections and voltage •
Connect power and charge the battery
Poor accuracy Improper calibration •
Unstable environment Perform calibration •
Move scale to suitable location
Unable to calibrate Unstable environment •
Incorrect calibration mass Move the scale to suitable location •
Use correct calibration mass
Scale flashes Bat Battery discharged Connect power and charge the battery
Battery fails to charge
fully Battery is defective Have battery replaced by authorized
service dealer
ZEro-E Pan has load during power on Remove weight from pan and re-zero
ZEro-E Pan was removed Install pan and re-zero.
-Over- Weight on pan exceeds
capacity Remove weight from the pan
Err-01 Invalid under and over limit
settings Re-enter under and over limits
Ad-Lo Incorrect Calibration Setting or
incorrect Calibration weight Correct the Calibration setting or
Calibration weight
5.3 Service Information
If the troubleshooting section does not resolve or describe your problem, contact
your authorized Ohaus service agent. For service assistance or technical support in
the United States call toll-free 1-800-526-0659 between 8.00 AM and 5:00 PM
EST. An Ohaus product service specialist will be available to provide assistance.
Outside the USA, please visit our web site,
www.ohaus.com to locate the Ohaus
office nearest you.