Ohaus CARAT PLUS PRECISION JEWELRY BALANCES Density Determination Kit Manual - Manual (Page 3)

3
PREPARING THE BALANCE FOR DENSITY DETERMINATIONS
1. Remove the pan from the balance.
2. Refer to Figures 3, 4 and 5 and determine which bracket assembly is required
for your balance.
Figure 3 shows the bracket assembly as shipped for use with the Explorer,
Explorer Pro, Voyager, and Voyager Pro balance models.
Figure 4 shows the bracket assembly modified for use with the Adventurer
balance models. Loosen the screw, add the spacer and reassemble the
mounting stud with the new screw.
Figure 5 shows the bracket assembly modified for use with the Adventurer Pro
and Adventurer SL balance models. Loosen the screw and reassemble with the
cone adapter and the original screw.
3. Insert the bracket into the balance where the pan was removed from. Figure 6.
Balance
Spacer
Old Screw
New Screw
Figure 3. Figure 4. Figure 5.
Mounting Stud
Bracket
Cone Adapter
4. On Explorer, Explorer Pro, Voyager and Voyager Pro balances which are rated over
400g, place the Equalizing Washer on top of the Bracket as shown in Figure 6.
5. Place the Support into position over the bracket making sure the Support does not
make contact with the Bracket as shown in Figure 7.
6. Allow the balance to warm up sufficiently before making measurements.
Figure 7. Support Mounting.
Old Screw
Pan
Figure 6. Bracket and Washer Mounting.
Support
Equalizing
Washer
Mounting Stud
Bracket
density kit.pmd 8/9/2005, 1:12 PM 3