Ohaus TP Series Electronic Balance - Manual (Page 77)

24
Reset to Factory Defaults Reset to Factory Defaults Reset to Factory Defaults Reset to Factory Defaults Reset to Factory Defaults
This submenu enables you to reset all
User menu selections to the factory de-
fault settings outlined in the adjacent table.
To reset to factory defaults:
1. Access the Reset submenu.
2. Press to change the setting.
Select YES to reset settings or,
no to leave current settings.
Press to accept the displayed
setting.
To access a submenu:
1. Repeatedly press until the de-
sired submenu is displayed.
2. Press to select the displayed
submenu.
NOTE NOTE NOTE NOTE NOTE: You must use END to store any
changes you make to the User menu.
The following sections describe each item
on the User menu in detail.
ON ON ON ON ON
TARE TARE TARE TARE TARE
USER MENU USER MENU USER MENU USER MENU USER MENU
FACTORY DEFAULTS FACTORY DEFAULTS FACTORY DEFAULTS FACTORY DEFAULTS FACTORY DEFAULTS
Averaging Level AL 1
Stability Range 1d
Auto-Zero Tracking .5d
MODE MODE MODE MODE MODE
ON ON ON ON ON
TARE TARE TARE TARE TARE
MODE MODE MODE MODE MODE