Ohaus TP Series Electronic Balance - Manual (Page 82)

29
1. Access the Reset submenu.
2. Press to change the setting.
Select YES to reset settings or,
no to leave current settings.
Press to accept the displayed
setting.
To access the Setup menu, press and
hold until SETUP is displayed, then
release it.
To access a submenu:
1. Repeatedly press until the de-
sired submenu is displayed.
2. Press to select the displayed
submenu.
NOTE: NOTE: NOTE: NOTE: NOTE: You must use END to store any
changes you make to the Setup menu.
The following sections describe each item
on the Setup menu in detail.
MODE MODE MODE MODE MODE
ON ON ON ON ON
TARE TARE TARE TARE TARE
ON ON ON ON ON
TARE TARE TARE TARE TARE
Reset to Factory Defaults Reset to Factory Defaults Reset to Factory Defaults Reset to Factory Defaults Reset to Factory Defaults
This submenu enables you to reset all
Setup menu selections to the factory de-
fault settings outlined in the adjacent table.
To reset to factory defaults:
SETUP MENU SETUP MENU SETUP MENU SETUP MENU SETUP MENU
FACTORY DEFAULTS FACTORY DEFAULTS FACTORY DEFAULTS FACTORY DEFAULTS FACTORY DEFAULTS
Unit Selection On g
Conversion Factor
Mantissa 1.000000
Exponent 0
LSD 1
PC Error Level OFF
PC Alt. Display TOTAL PCS
% Alt. Display TOTAL %
MODE MODE MODE MODE MODE
ON ON ON ON ON
TARE TARE TARE TARE TARE