Spicer Tandem Drive Axles Pro-40 Single Reduction and Single Reduction with Differential Lock User Manual
Page 22
19
22
Forward Assembly
8. Install helical side gear and snap ring.
9. Install
input shaft drive assembly into the carrier.
10. Install shift fork, compression spring and shift rod.
During installation of power divider components, a part
may fall from the carrier. Use caution to prevent injury or
damage.
11. Install plastic trough in power divider cover.
12. Install power divider cover to carrier. Use Dana
approved RTV compound on the carrier mating sur-
face. Torque cap screws to 114–140 lb-ft. (155–190
N•m).
Note: Gasket compound will harden in 20 minutes. Install
power divider quickly as possible to avoid future leaks.
13. Install input cage shim and input cage assembly.
14. Install input cage cap screws and tighten until snug.
15. Measure and adjust input shaft end-play, see page 28.
16. Torque input cage cap screws to 114–140 lb-ft.
(155–190 N•m).
17. Install NEW input seal.
18. Reinstall input yoke.
CAUTION
Fo
rward Assembly