Spicer Tandem Drive Axles Pro-40 Single Reduction and Single Reduction with Differential Lock - Manual (Page 73)

70 74
16. Install a side pinion and thrust washer on the half
shaft side.
17. Install the half shaft so that the pin is facing upward
and push it in until it stops.
18. The end of the half shaft should fit into the slot of
the full shaft at the same time as the hole in the case
lines up with the hole in the half shaft.
19. Install the locking pins to both sides of the differen-
tial case.
20. Install outer side gear.
Note: No thrust washer is used at this location.
21. Lower the ring gear onto the case assembly aligning
the locking dowels.
Side Pinion
and Thrust
Washer
Pin Hole
Facing
Upward
Half
Differential
Shaft
Fit End
Into Slot
Align Pin
Holes
Locking
Pin
Wheel Differential