Spicer Tandem Drive Axles Pro-40 Single Reduction and Single Reduction with Differential Lock - Manual (Page 71)

68 72
5. The locking pins are slip fit and should fall from the
case easily.
6. Remove the half shafts first and then remove their
side pinions and thrust washers.
7. Remove the full shaft, side pinions and thrust washers.
8. Remove inner side gear and thrust washer.
9. Remove bearing cones from ring gear and differen-
tial case in two steps:
a. Mount puller vertically to split bearing. This
action will start moving the bearing off case and
gear.
b. Mount puller horizontally to remove cone.
Half
Differential
Shaft
Wheel Differential