Velleman К8048 - Manual (Page 12)

PIC programmer board 10
* Attention: Place SW5 in the 'PROG'-position in order to use this function !
4. Enables the user to view and modify data stored in a controller's EEPROM. * Attention: Place
SW5 in the 'PROG'-position in order to use this function !
5. Leave this adjustment in the standard setting : 'NORMAL'. When you're having trouble
programming you can set the speed on 'HIGH' if you have a slow PC or you can select 'LOW' if
your PC is extremely fast. This compensates for the difference in speed.
6. Enables you to see which address or address area the software uses to read or write.
7. Name of the file loaded in the memory and to be used for the programming.
6.4 Erase pic device
Erasing the contents of a controller:
1. Is used to erase the entire contents of a program from a controller.
2. Only used to erase the EEPROM data.
3. Can be used to deactivate the code protection. However, you will no longer be able to read the
contents or use the program.
* Attention: Put SW5 in the 'PROG' position to use this function !
1. Is used to erase the entire contents of a program from a controller.
2. Only used to erase the EEPROM data.
3. Can be used to deactivate the code protection. However, you will no longer be able to read the
contents or use the program.
Read the C:\Velleman\K8048\Examples folder for examples of programs.
Updates of the programming software and additional examples can be downloaded from our site
www.velleman.be