Velleman К8048 - Manual (Page 9)

Programming Procedure 7
K8048 © 2003 Velleman Components
The assembler will now generate the following files:
· xxx.ERR => Error file, contains all errors and/or all warnings MPASM assembler has located
in your source code
· xxx.Hex => This is the actual machine code file to be used by the programming software for
the programming of the controller).
· xxx.LST => Listing file, contains your source code and the additional remarks generated by
the assembler.
· xxx.COD => Code file, is only used by the MPLAB programming environment and NOT by the
K8048 software.
6.3 Actual programming of the microcontroller
· Connect your K8048 with your computer via a free serial port.
· The IRQ line of this erial port (IRQ 3 or 4) must not be used by another device e.g. internal
modem.
· Connect the suitable power adapter and verify whether LD7 lights up ("Power LED").
· Start the 'PROGPIC2, PIC programmer' program (in the folder C:\Velleman\K8048\).
· Click on 'FILE' -> 'OPEN' and select the compiled program (Hex 8M-file) you want to program.