K6727 – Velleman projects K6727 Assembly instructions User Manual
Page 13
Advertising
13
From one receiver, the jumpers J1 and J2 must be cut, this receiver must not be adjusted with the transmitter.
21. Using 2 receivers at the same place
K6727
Rx
GND
J1
J2
J1 & J2 CLOSED
ADJUST ONLY THIS RECEIVER
K6727
DO NOT ADJUST THIS RECEIVER
J1 & J2 OPEN
J2
J1
Rx
GND
The circuit can also be installed in a plastic housing (NOT A METAL BOX) e.g. WCAH2851.
Place the housing in a place where there are few metal parts. It may be the case that after installation, the circuit
will have to be retuned. This is because of the influence of metal parts in the vicinity of the circuit.
22. About the housing
Connection
Advertising