Veris Technologies pH Manager - Operating Instructions - Manual (Page 14)

Pub.# OM17-MSP-pH
3-6
pH Data Recording
Figure 20
For EC mapping, press the #1 key. #4 returns you to the initial start-up screen. Select #3 EC+pH
to collect EC and pH data. Pressing #1 or #3 brings up the next screen:
Figure 21
The DataLogger is displaying the map file number it is creating, in case you want to record it along
with any other information about the field. Press any key to begin new map file. After starting the
file, pressing the #4 key will stop the file. If DataLogger freezes at the screen shown in Figure 20 or
Figure 21, check formatting of SD card
—must be FAT format.
If memory card was not inserted during boot-up, the following screen will appear:
Figure 22
Install card and re-start DataLogger. NEVER REMOVE CARD WHILE LOGGING DATA.
If you pressed the option #1 for EC, this is the next screen:
Figure 23