Veris Technologies pH Manager - Operating Instructions User Manual
Page 44
Pub.# OM17-MSP-pH
5-4
Wear Item Replacement
Inspect cutting shoe for wear and gouges, replace as needed. Knock old shoe off with punch and
tap new shoe on, as shown here. TIP: Rotate cutting shoe to prolong wear life.
Figures 28a and 28b
Replace sampling trough liner, scraper cutting edge when wear is apparent.
Lubrication
• Pinch point hazard: to prevent injury, stand clear when raising or lowering any part of the Veris
MSP. Disengage automatic cycling function before working around unit.
• Install all transport locks before transporting or working underneath.
Rockshaft pivot points
– Each pivot (located at the left and right) contains
an upper and lower grease zerk. Due to the limited motion of the
rockshaft, these should be lubricated on 40-hour intervals. This may
vary based on the number of times the unit is raised and lowered.
Figure 29
knock worn shoe off
from rear
tap new shoe on
with 2x4
Pivot grease
zerks (2 per
hangar; 4 total )