V-Tech DT597 Manual - Manual (Page 4)

Lock Control Jumper: To select the lock type.
Door Station Code DIP: Total 4 door stations can be supported.
T/R+,T/R-: USB-RS485 communication terminal.
Main Connect Port: To connect the bus line and the electronic locks.
BUS: Connect to the bus line, non-polarity.
PL: External lock power input, connect to the power positive(power +).
S1+, S2+: Lock power(+) output, to connect 2 locks.
S-: Lock power(-) output.
Door Station Mounting
OPEN CLOSE 90°
1 2 3 4
Adjusting Camera Angle
Use a screwdriver to loosen
the screw and then adjust the
angle of the camera ,then fix
the screw.
Steps:
1. Drill a hole in appropriate size, then attach the mounting box to the hole.
2. Adjust the camera angle, and connect the cable correctly.
3. Attach the front panel to the mounting box.
4. Use the special spanner to move 90 0 to fix the front panel.
-4-