VTech IS7121_-2-22 Manual - Manual (Page 19)

Getting started
14
Doorbell installation
Make sure to test the reception and the doorbell position before you mount the
doorbell on the wall.
See Locating the doorbell on pages 10-13 to choose a desirable position for the
doorbell. Use a pencil to mark two holes on the desired location. Then remove the
wall mount and drill two holes in the wall. Check for reception strength and camera
angle before drilling the holes.
1.
If you drill the holes into a stud, go to step 3.
-OR-
If you drill the holes into an object other than a stud, insert the wall anchors into the
holes and tap gently on the ends with a hammer until the wall anchors are flush
with the wall.
2.