Vutec SILVERSTAR - Installation Instructions User Manual
Silverstar, With standard frame
INSTALLATION INSTRUCTIONS
SilverStar
*
with standard frame
General
The screen is fully assembled from the factory and ready to be mounted.
Unless mounting to wall studs; suitable wall anchors (not supplied) must be used to provide adequate support for the screen.
Figure
1 Figure
2
Installation
Referring to Figure 2, determine Dim K, the bracket vertical locations. The bracket horizontal locations are located 1/4 of viewing
width to the left and 1/4 of viewing width to the right to the setscrews locations.
Install the wall mount brackets. Be sure the brackets are level and tighten the screws.
Referring to Figure 1, place the screen such that the rear channel fit into the wall mount brackets. Tighten the setscrews to hold the
screen in place.
Notice the wall mount bracket may be adjusted up and down to properly fit inside the screen rear channel. Make adjustments as
necessary.
Accessories Included
Description
QTY.
Wall mount bracket
4
#8 x 11/2 long, Phillip head screw
8
1/4-20 x 1/4 long, slot head setscrew
4
*
Patent
No. 7,057,812
VUTEC CORPORATION
2741 N.E. 4
th
Avenue
Pompano Beach, FL 33064
TEL: (954) 545
-9000 | FAX: (954) 545-9011
E-MAIL: