Vutec ELEGANTE FIXED - Installation Instructions - Manual

VUTEC CORPORATION
11711W. Sample Road
Coral Springs, FL 33065
TEL: (954) 545 9000 - FAX: (954) 545 9011
E-MAIL: [email protected]
INSTALLATION INSTRUCTIONS
Elegante Fixed Frame Wall Screen
Frame Assembly
Place the screen frames on a flat and cleaned surface with the backside face up.
Referring to Figure 3, a pair of blank and tapped corner brackets is used to form the screen frame. Insert the brackets in the channel
of the frame. Install four set screws to each of the tapped corner brackets. Tighten the set screws to expand the brackets and to grip
the frames. Be sure the assembled frame is square. Make adjustments as necessary.
Unless mounting to wall studs; suitable wall anchors (not supplied) must be used to provide adequate support for the screen.
Figure
1 Figure 2
Screen Shown Without Fabric Side View Mounting
Installation
Do not install the screen fabric to the frame yet!
Determine a location on the wall for the screen.
Referring to Figures 1 and 2, install the two wall mount brackets onto the wall. Be sure they are level then tighten the screws. Add
a third bracket in the middle for screen width of 96 inches and larger.
Hang the screen frame. Locate and install a wall mount bracket to the bottom screen frame.
Note: The middle top and bottom brackets prevent large size frame from bowing like ‘Hour Glass’.