VEGA VEGAPULS 68 (≥ 2.0.0 - ≤ 3.8) 4 … 20 mA_HART four-wire - Manual (Page 38)

l SIL
C opy sensor data
C opy sensor data?
Basic adjustment
I
f the "Reset" is carried out, the sensor resets the values of the
following functions to the reset values (see chart): 1)
Function Reset value
M ax. adjustment 0 m(d)
M in. adjustment 15 m(d) (VEGAPULS 67)
70 m(d) (VEGAPULS 68)
M edium B ulk solid
V essel form not known
D amping 0 s
L inearisation linear
S ensor-TAG S ensor
D isplayed value D istance
E xtended settings N one
C urrent output - characteristics 4 … 20 mA
C urrent output - max. current 20 mA
C urrent output - min. current 4 mA
C urrent output - failure < 3.6 mA
U nit of measurement m(d)
T he values of the following functions are not reset to the reset values
( see chart) with "Reset":
Function Reset value
L ighting no reset
L anguage no reset
SIL no reset
HART mode no reset
Factory setting
L
ike basic adjustment, furthermore special parameters are reset to
default values. 2)
1) S ensor-specific basic adjustment.
2) S pecial parameters are parameters which are set customer-specifically on
the service level with the adjustment software PACTware.
Reset
38 VEGAPULS 68 • 4 … 20 mA/HART four-wire
6 S et up with the indicating and adjustment module PLICSCOM
29262
-EN
-090305