VEGA PLICSMOBILE T61 - Manual (Page 27)

27
7 Setup
PLICSMOBILE T61 • External GSM/GPRS radio unit
37700-EN-130228
When PLICSMOBILE is in power saving mode, a login procedure can
be triggered by briefly pushing the test key. The user can thus check
via the status LED whether a login into the GSM network is possible.
7.5 Internet connection and measured value
transmission
The transmission of measured values via e-mail or to the visualization
software WEB-VV is always based on an Internet connection. Access
data (user name/password) are required for this connection. With
a GSM connection, a dial-in number is also required; with a GPRS
connection, the APN (Access Point Name) must be given. You can get
this information from your mobile phone provider. Further information
and a list of common mobile phone providers with their access data
can be found in the online help of the PLICSMOBILE DTM.
Fig. 13: Entering the Internet access data
The measured values can be transmitted optionally in the following
ways:
•
Via integrated mail client to any e-mail address
•
Via SMS to any mobile phone
•
Via http to the visualization software WEB-VV
Under the DTM menu item "Event list" there is a convenient assistant
for setting up measured value transmission. The measured values can
be transmitted at individually definable times or intervals. A message
can also be triggered when a certain level is exceeded or underrun.
In addition, a status-controlled measured value transmission can be
carried out, for example when a fault signal occurs.
Test key
Internet connection (Dial-
Out)
Measured value transmis-
sion