3 exchanging the electronics module, 4 software update – VEGA VEGADIF 65 4 … 20 mA_HART User Manual

Page 72

Advertising
background image

72

9 Maintenance and fault rectification

VEGADIF 65 • 4 … 20 mA/HART

36128-EN-130417

Error code Cause

Rectification

4 … 20 mA

signal miss-

ing

Wrong connection to

voltage supply

– Check connection according to

chapter "Connection steps" and

if necessary, correct according to

chapter "Wiring plan"

No power supply

– Check cables for breaks; repair if

necessary

Operating voltage

too low or load resist-

ance too high

– Check, adapt if necessary

Current sig-

nal greater

than 22 mA

or less than

3.6 mA

Electronics module

or measuring cell de-

fective

– Exchange the instrument or send it

in for repair

In Ex applications, the regulations for the wiring of intrinsically safe

circuits must be observed.

Error code Cause

Rectification

E013

no measured value

available

6)

– Exchange the instrument or send it

in for repair

E017

Adjustment span too

small

– repeat with modified values

E036

no operable sensor

software

– Carry out a software update or send

instrument for repair

E041

Hardware error

– Exchange the instrument or send it

in for repair

Depending on the reason for the fault and the measures taken, the

steps described in chapter "Set up" may have to be carried out again.

9.3 Exchanging the electronics module

In case of a defect, the electronics module can be exchanged against

an identical type by the user. If no electronics module is available on

site, the module can be ordered from the agency serving you.
In Ex applications only one instrument and one electronics module

with respective Ex approval may be used.
The sensor serial number is required to order an exchange electron-

ics. You will find this number on the type label of the instrument or on

the delivery note.

9.4 Software update

The software version of VEGADIF 65 can be determined as follows:

on the type label of the electronics

Via the display and adjustment module

via PACTware

Error messages via the

display and adjustment

module

Reaction after fault recti-

fication

6)

Fault message can also appear if the pressure is higher than the nominal

range.

Advertising