Atdec Telehook TH-VA-2X2-SHARPV6012 Installation manual - Manual (Page 2)

Rev.01-08/11
Figure 1
Figure 2
Figure 3
Step 1: Mount Frame to
Wall
Scribe a horizontal line on the
wall showing the exact
location of where the top edge
of the upper left monitor will
be. Measure down 5.74”
(145.8mm) from that line and
scribe another horizontal line
showing where the top edge
of the mounting frame will be
(Figure 1).
Scribe a vertical line showing
where the left side of the
upper monitor will be.
Measure to the right and
scribe another vertical line
14.72” (374mm) to locate the
left edge of the vertical
mounting channel (Figure 1).
Using a level, place the frame
up to the vertical and horizontal mounting frame scribe
lines. Use the frame as a template to mark the six
primary mounting key-holes.
Place the frame back on the floor and install wall
fasteners, leaving at least ¼” (7mm) of the bolt’s shaft
exposed (Figure 2).
Replace and level the mount on the wall and install
additional wall fasteners to the top, lower horizontal
slots and the center hole of the vertical mounting
channel. Tighten wall fasteners permanently.
Step 2: Install Media Player (Optional)
Choose and remove the bottom left or right horizontal frame channel by
unscrewing its flat head screws (Figure 3). Install the media player to
the wall between the two vertical channels using the appropriate
fasteners through the media player’s brackets (Figure 3). Re-install the
bottom channel.