Velleman VDPC148 - Manual (Page 3)

VDPC148 VELLEMAN 3
VDPC148 — 48-CHANNEL DMX LIGHT CONTROL PANEL
1. Introduction & Features
To all residents of the European Union
Important environmental information about this product
This symbol on the device or the package indicates that disposal of the device after its lifecycle could harm
the environment.
Do not dispose of the unit (or batteries) as unsorted municipal waste; it should be taken to a specialised
company for recycling.
This device should be returned to your distributor or to a local recycling service.
Respect the local environmental rules.
If in doubt, contact your local waste disposal authorities.
Thank you for buying the VDPC148. It is a unique 48 DMX-channel light control panel. This unit has been tested at
the factory before being shipped to you; there is no assembly required. Please read the manual thoroughly before
bringing this device into service. If the device was damaged in transit, don't install or use it and contact your dealer.
It features:
• 48 DMX control channels
• 96 chaser programs
• 2 independent dipless crossfaders
• 3-digit LCD display
• digital technology
• power failure memory
• standard MIDI and DMX ports
• powerful program edit
• various programs edit
• several programs can run synchronously
2. Safety Instructions
• Often clearing the memory may cause damage to the memory chip, be careful not to initialise your unit frequency
often to avoid this risk.
• Only use the recommended AC/DC power adapter.
• Keep the original packaging in case you should ever have to return to unit for service.
• Do not spill water or liquids in or onto your amplifier.
• Make sure that the power outlet voltage matches the voltage of your amplifier.
• Do not crimp the power cord and protect it against damage. Have an authorised dealer replace it if necessary.
Avoid the power cord being stepped upon or tripped over.
• Never remove the ground prong from the power cord. This prong is used to reduce the risk of electrical shock in
case of an internal short circuit.
• Disconnect the device from the mains to clean it or when it is not in use. Handle the power cord by the plug only.
Be very careful during the installation: touching live wires can cause life-threatening electroshocks.
Do not touch the device during operation as the housing heats up.
Keep this device away from rain and moisture.
Unplug the mains lead before opening the housing.