Velleman VDPC148 - Manual (Page 6)

VDPC148 VELLEMAN 6
b) Rear Panel (fig. 2)
35. Power switch
Use this switch to turn the device on or off.
36. DC input
DC 13-18V, 500mA min.
37. MIDI Thru/Out/In
MIDI ports for connection to a sequencer or MIDI device.
38. DMX Out
This connector sends your DMX value to the DMX fixture or DMX pack.
39. DMX polarity select
Used to select the DMX polarity.
40. Audio input
This jack accepts a line level audio input signal ranged from 100Mv to 1Vpp.
41. Remote input
Black out and full on may be controlled by a remote control using a standard ¼” stereo jack.
5. Operation
a) Programming
RECORD ENABLE
1) Press and hold down the record button.
2) While holding down the record button, press the flash buttons 1, 6, 6 and 8 in sequence.
3) Release the record button, the record LED will light. Now you can begin programming your chase patterns.
NOTE:
The first time you turn on your unit, the default setting of the record code is flash buttons 1, 6, 6 and 8.
You can change the record code to protect your programs.
PROGRAM SECURITY
To protect your programs from editing by others, you can change the record code.
1) Enter the current record code (flash buttons 1, 6, 6 and 8)
2) Press and hold down the record and edit buttons at the same time.
3) While holding down the record and edit buttons, push the desired flash buttons to enter a new record code.
The record code consists of 4 flash buttons (the same button or different ones), make sure your code
consists of 4 buttons.
4) Enter your new record code a second time, all channel LEDs and scene LEDs will flash three times. The
record code has now been changed.