Velleman VDPC148 - Manual (Page 7)

VDPC148 VELLEMAN 7
5) Exit the record mode. Push the REC exit button while pressing and holding down the record button, release
the buttons at the same time. The record mode is now engaged.
IMPORTANT!
Always remember to exit the record mode when you don't continue your programming, otherwise you could
loose control over your unit.
PROGRAMMING SCENES
1) Record enable.
2) Select the 1-48 single mode by pressing the mode select button. This will give control of all 48 channels during
programming.
Make sure that master A & B are both set to maximum (master A is at its maximum in the fully up position, master
B is at its maximum in the fully down position)
3) Create a desired scene using channel sliders 1-48. At 0% or DMX 255 these sliders should be at
position 10.
4) Once the scene is satisfactory, press the record button to program the scene as a step into the memory.
5) Repeat steps 3 and 4 until all desired steps have been programmed into memory. You can program up to 1000
steps into the memory.
6) Select a chase bank or scene master to store your program. Press the page button select a page (page 1-to store
your scenes.
7) Press a flash button between 25-48 while holding down the record button. All LEDs will flash indicating the scenes
have been programmed into memory.
8) You can continue programming or you can exit. To exit the program mode, press the exit button while holding
down the record button, the LED should go out.
EXAMPLE: program a 16-step chase with channels 1-32 at full in sequence into Flash button 25 of page 1
1) Record enable.
2) Put the masters A& B in the maximum position and slide the fade slider to the top.
3) Press the mode select button to select 1-48 signal mode.
4) Slide the channel slider 1 to the top position, its LED will light at full intensity.
5) Press the record button to program this step into the memory.
6) Repeat steps 4 and 5 until you have programmed channel sliders 1-32
7) Press the page button for chasing page 1, the LED will light.
8) Press page button 25 while holding down the record button; all LEDS will flash, indicating you have
programmed the chase into the memory.
b) Editing
EDIT ENABLE
1) Record enable.
2) Use the page button to select the page on which the program you wish to edit should be.
3) Press the mode select button to select CHNS◄►SCENES.
4) Press and hold down the edit button.
5) While holding down the edit button, press the flash button that corresponds to the program you wish to edit.
6) Release the edit button, the corresponding scene LED should light indicating you are in edit mode.
ERASING A PROGRAM
1) Record enable.
2) Use the page button to select the page the program you wish to erase is on.
3) While holding down the edit button, press the flash button (25-48) twice.
4) Release the two buttons. All LEDS will flash, indicating the program has been erased.