Velleman VDPDP152 - Manual (Page 3)

VDPDP152_v3 VELLEMAN 3
• Do not remove the serial number sticker from the device as doing so will void the warranty. Only use the device
for its intended purpose. All other uses may cause short circuits, burns, electroshocks, lamp explosions, crashes,
etc. Using the device in an unauthorised way will void the warranty.
4. Description
a) Front Panel
b) Connections
The output goes through 4 SCHUKO output sockets and a load can be connected to each of these. The max. load
per channel is 1100W (5A). Please keep in mind never to surpass the maximum total current of 16A!!
5. Operating Instructions
Analogue Connection
Fix the device and put the circuit breaker at the back in the OFF-position. Connect the analogue controller with the
device via an 8-pin cable. Put the output of the analogue controller in the minimum position. Connect the load on the
SCHUKO output sockets.
When all connections are made, connect the device to the mains and turn on the circuit breaker. Adjust the output of
the analogue controller to adjust the corresponding load on the selected channel.
DMX Connection
Fix the device and put the circuit breaker at the back in the OFF-position. Connect the DMX device into the DMX
chain by means of a 3-pin XLR cable. Connect the load with the SCHUKO output sockets.
Define the DMX start address of the device by means of the DIP switches according to the table given below :
Fig. 1
Fig. 2