Velleman HAMGSMGPS - Manual (Page 23)

SMS MESSAGES SENDING AND RECEIVING
The LED on the push button will blink 3 times as soon as the AMA2/3 receives the message.
After about 45 seconds the LED on the push button will power on and off twice, followed by a steady
burning during 5 seconds to indicate the message has been sent. If not, please check your
SMS, SIM-card or password and try again.
2.1. WHICH CELL PHONE WILL RECEIVE THE SMS MESSAGE?
After receiving the GSM-network signal, please program your cell phone number in the AMA2/3.
The cell phone number of the user is f.e.: 0123/456789
Send the following message to the AMA2/3: A1111+xx123456789.
A = stands for ALARM
1111 = stands for default password
+xx = stands for the international dialing code
123456789 = stands for the cell phone number of the receiver
Do not enter any spaces before or in your message. After about 45 seconds the AMA2/3 will send an
SMS message to the input dialing numbers to confirm:
AMA2/3 REV 4.30
PW= 1111
TEL=+xx123456789
2.2. PERSONAL PASSWORD
Desired personal password f.e.: 1234
Send the following message to the AMA2/3 (this could be digits or caracters) : P11111234
P = stands for PASSWORD
1111 = stands for default password
1234 = stands for a new password
Do not enter any spaces before or in your message. After about 45 seconds the AMA2/3 will send a
SMS message to the input dialing numbers to confirm:
AMA2/3 REV 4.30
PW= 1234
TEL=+xx123456789
2.3. FUNCTIONS AND DEFAULT VALUES
Send the following message depending on the programming: Fxxxxy=z
F = stands for FUNCTION
xxxx = stands for default password
y = stands for desired function from 1 to 5
z = stands for value 0 to z depending on the function
Do not enter any spaces before or in your message. After about 45 seconds the AMA2/3 will send a
SMS message to confirm:
AMA2/3 REV 4.30
PROG=0,2,7,2,3 (function 1,2,3,4 en 5)
22