Velleman HAMGSMGPS - Manual (Page 29)

3.8. TEMPORARY ACTIVATION OF THE SERVICE MODE
Press the push button while switching “OFF” the contact. The moment you hear a long audible signal,
release the push button. From this moment the service mode is activated until you switch “ON” the
contact again. This function permits you to get fuel or wash your vehicle.
3.9. FOLLOWING THE VEHICLE ON THE INTERNET (only for AMA3)
You can activate the “TRACKING”-mode. The AMA3 will send you a status message every minute for
a maximum of 1 hour.
The tracking function can be switched ON or OFF any time by sending a SMS with the following
message: TRACK
After about 45 seconds the AMA3 will send a SMS message to confirm:
AMA3 REV 4.30
TRACK ON (or) OFF
CONTACT: OFF
BAT=OK SIG=4
GPS=0/1
TIME:201446
DATE:010707
50:55:34 N
005:26:31 E
SPEED:0.00
OUTPUT OFF/ON
If you fill in the coordinates on our website www.amasystems.be , choose your language and go to
“Standard Format” , push the “OK”-button. Now the location of your vehicle will be visualized.
4. GPS-CHECK FUNCTION
Attention:The first time after installing the AMA3, it can take about 10 minutes before AMA3 has
got sufficient satellite information to operate properly
.
Each time the ignition key is turned on, the GPS-receiver starts collecting satellite data. This can take
up to 2 minutes to collect the satellite information it needs. You can check if you have GPS signal.
Activating the GPS check-function
Turn on the ignition key and hold the LED push button (this can last for 10 seconds) until you hear two
buzzer signals. The test can be done while driving the vehicle. Each time AMA3 receives a valid GPS-
signal you’ll hear 2 short buzzer signals. When the GPS-signal is OK, you will hear them every 3
seconds
.
Deactivating the GPS check-function
There are 2 different ways to do it:
1) Turn OFF the ignition key.
2) Hold the LED push button (this can last for 10 seconds), until you hear 1 long buzzer signal.
28