Velleman HAA2890 User Manual
Page 26
26
THE OPERATION MODES (Location 94)
Four operation modes are available for the selection. The codes are 0, 1, 2 and 3.
WIEGAND OUTPUT AT KEYPAD OPERATION MODE
0 --- Stand Alone Keypad Mode -- (Default)
The system provides full functions to operate its outputs.
1 --- Card & Code Reader Mode (Not Available in this model)
2 --- Master Keypad of Split-Decoded Mode
The Master keypad will transfer all the programmed feature data (except the user PINs, Codes and Cards data) to the
Access Controller (decoder) right after it exits the programming mode. A Split-decoded keypad system needs at least
one Master keypad and one Access Controller to work.
3 --- Slave Keypad of Split-Decoded Mode
No feature data is transferred to the Access Controller (decoder) from the Slave keypad. It takes the same feature
data from the Master keypad to operate. The Slave keypad(s) is for a Split-Decoded system that needs more than one
keypads for operation convenience.
NOTE:
a) Do not set more than one keypads in Master mode in a Split-Decoded system. Otherwise, the data will be confused.
b) Each keypad in Split-Decoded mode can be programmed independently with its own user PINs, Codes and Cards.
The PINs, Codes and Cards can be repeatedly used in other keypads in the same system.
OPERATION MODE
LOCATION
VALIDATION
#
0
,
1
,
2
or
3
94
HAA2890_Manual.indd 14
24/05/2012 15:21:13