Velleman HAA2866 User Manual
Page 31
30
THE OPERATION MODES AND THE WIEGAND OUTPUT (Location 94)
Four operation modes are available for the selection. The codes are 0, 1, 2 and 3.
WIEGAND OUTPUT AT KEYPAD OPERATION MODE
0 --- Stand Alone Keypad Mode -- (Default)
The system provides full functions to operate its outputs and at the same time provides Wiegand Data
Output for all the VALID Cards and User PINs including the Duress Codes and Visitor Codes. No
Wiegand Data Output for the invalid PINs and Cards.
1 --- Card & Code Reader Mode
In the Card & Code Reader Mode, the keypad provides Wiegand Data Output for all the Card
readings and PINs/Code entries but does not operate its outputs. It is solely a card and code reader.
NOTE:
It is suggested to clean all the codes, PINs and cards that were previously stored in the system before
setting the system for reader mode.
2 --- Master Keypad of Split-Decoded Mode
The keypad unit provides the Wiegand Data Output for the valid user PINs, Codes and Cards exactly
like in the Stand Alone Mode. The Master keypad will transfer all the programmed feature data
(except the user PINs, Codes and Cards data) to the Access Controller (decoder) right after it exits
the programming mode. A Split-decoded keypad system needs at least one Master keypad and one
Access Controller to work.
3 --- Slave Keypad of Split-Decoded Mode
The Keypad unit provides the Wiegand Data Output for the valid user PINs, Codes and Cards exactly
like in Stand Alone Mode. No feature data is transferred to the Access Controller (decoder) from the
Slave keypad. It takes the same feature data from the Master keypad to operate. The Slave keypad(s)
is for a Split-Decoded system that needs more than one keypads for operation convenience.
NOTE:
a)
b)
OPERATION MODE
LOCATION
VALIDATION
#
0
,
1
,
2
or
3
94
Do not set more than one keypads in Master mode in a Split-Decoded system. Otherwise, the data
will be confused.
Each keypad in Split-Decoded mode can be programmed independently with its own user PINs,
Codes and Cards. The PINs, Codes and Cards can be repeatedly used in other keypads in the
same system.