ACP HDC182 Owner's Manual - Manual (Page 11)

11
User Options
Follow the instructions below to customized the
microwave oven’s operation. End-of-cycle signal,
maximum cooking time and other options can be
changed to meeting your cooking needs. Example:
Change setting to single digit pad operation.
1. Open oven door.
• If door is closed or STOP/ RESET pad is
pressed before finishing programming sequence,
oven exits programming mode.
2. Press and hold pad 2 for approximately 5 seconds.
• After 5 seconds, signal sounds. Display shows
“OPTIONS”.
3. Press 9 pad.
• See table for options.
• Displays shows “OP:90”.
• “OP” represents optional program mode, first
number represents option number and second
number represents functions currently selected for
option.
4. Press 9 pad repeatedly to change setting.
5. Press START pad to save changes.
• Repeat steps 3-5 to change additional options.
• Changes appear after door is closed or STOP/
RESET is pressed.
6. Press STOP/RESET pad or close oven door
to exit programming mode.
Numbered Pads Display Options ( Factory Settings in Bold)
1
End of Cycle Beep
OP:10
OP:11
OP:12 3 second continuous beep
Continuous beep until door is opened
5 beeps bursts until door is opened
2
Speaker Volume
OP:20
OP:21
OP:22
OP:23 Eliminates beep
Sets volume to low
Sets volume to medium
Sets volume to high
3
Key Beep
OP:30
OP:31 Prevents beep when pad is pressed.
Allows beep when pad is pressed.
4
Keyboard Enable
Window
OP:40
OP:41
OP:42
OP:43 15 seconds after oven door is opened, keyboard disabled
30 seconds after oven door is opened, keyboard disabled
1 minute after oven door is opened, keyboard disabled
2 minutes after oven door is opened, keyboard disabled
5
Add Time during
Heating
OP:50
OP:51 Prevents adding heating time while oven is heating.
Allows adding heating time while oven is heating when a
memory pad is pressed.
6
Reset Door Open
OP:60
OP:61
Cancels heating time count down after door is opened during
cycle.
Allows oven to resume heating time countdown after door is
opened during cycle.
7
Maximum Heating
Time
OP:70
OP:71 Allows 60 minutes of heating time.
Allows 10 minutes of heating time.
8
Manual Operation
OP:80
OP:81 Allows use of preprogrammed pads only.
Allows use of manual time entry and preprogrammed pads.
9
Double Digit
Operation
OP:90
OP:91 Allows 10 (0-9) preprogrammed pads.
Allows 100 (00-99) preprogrammed pads.
0
Clean Filter
Message
OP:00
OP:01
OP:02
OP:03 Do not display message.
Display message for 24 hours every 7 days.
Display message for 24 hours every 30 days.
Display message for 24 hours every 90 days.
STYLE 1
Options