ACP HDC182 Owner's Manual - Manual (Page 16)

16
Changing user options
Options such as single or double pad programming, beep volume, and
maximum cooking time can be changed to suit individual preferences.
To change options:
1. Open oven door.
• If door is closed or RESET pad is pressed before programming is
complete, changes are discarded and microwave exits programming
mode.
2. Press and hold pad 2 for approximately 5 seconds.
• This begins options mode.
• Microwave will beep and 0P: displays. Microwave is now in
programming mode.
3. Press number pad that controls option to be changed.
• See table below for options.
• Current option will display.
4. Press number pad again to change the option.
• Each time pad is pressed, option will change.
• Match code displayed with code for desired option.
5. Press START pad to save changes.
• To change additional options, repeat steps 3 and 4.
• Changes appear after door is closed or STOP/RESET pad is pressed.
Numbered Pads Display Options ( Factory Settings in Bold)
1
End of Cycle Beep
OP:10
OP:11
OP:12 3 second continuous beep
Continuous beep until door is opened
5 beeps bursts until door is opened
2
Speaker Volume
OP:20
OP:21
OP:22
OP:23 Eliminates beep
Sets volume to low
Sets volume to medium
Sets volume to high
3
Key Beep
OP:30
OP:31 Prevents beep when pad is pressed.
Allows beep when pad is pressed.
4
Keyboard Enable
Window
OP:40
OP:41
OP:42
OP:43 15 seconds after oven door is opened, keyboard disabled
30 seconds after oven door is opened, keyboard disabled
1 minute after oven door is opened, keyboard disabled
2 minutes after oven door is opened, keyboard disabled
5
Add Time during
Heating
OP:50
OP:51 Prevents adding heating time while oven is heating.
Allows adding heating time while oven is heating when a
memory pad is pressed.
6
Reset Door Open
OP:60
OP:61
Cancels heating time count down after door is opened during
cycle.
Allows oven to resume heating time countdown after door is
opened during cycle.
7
Maximum Heating
Time
OP:70
OP:71 Allows 60 minutes of heating time.
Allows 10 minutes of heating time.
8
Manual Operation
OP:80
OP:81 Allows use of preprogrammed pads only.
Allows use of manual time entry and preprogrammed pads.
9
Double Digit
Operation
OP:90
OP:91 Allows 10 (0-9) preprogrammed pads.
Allows 100 (00-99) preprogrammed pads.
0
Clean Filter
Message
OP:00
OP:01
OP:02
OP:03 Do not display message.
Display message for 24 hours every 7 days.
Display message for 24 hours every 30 days.
Display message for 24 hours every 90 days.
Didn’t like an option?
Factory settings are marked in bold. To
change the oven back to the factory
setting, simply select the option that is
marked in bold.
My changes weren’t
saved.
In order for any changes to be
saved, the START pad must
be pressed after selecting
an option. Shutting the oven door or
pressing the STOP/RESET pad will not
Options
STYLE 2