Banks Power Ford Trucks: (Gas ’04 - 08 F-150 V6 & V8) Exhaust- Monster Exhaust, Dual out the back exit '04-10 F-150 4.2L, 4.6L & 5.4L (Non-Heritage models) - Manual (Page 11)

96317 v.5.0
11
16.
Move the spare-tire to the rear
of the vehicle and center between
the dual tailpipes such that there is a
minimum 1” of clearance around the
spare tire. Tighten the spare tire with
the manufacture tire tool so that it is
retained into place (See Figure 9).
17.
With the exhaust positioned
properly, begin to tighten the clamps
and hardware starting with the ones
closest to the front of the vehicle
and working your way back. Torque
the exhaust clamps evenly to 35
ft-lbs. Make sure that each slip is
fully inserted (+/- 1 ⁄
4
”). Torque the
rubber hanger factory M8 hardware
to 22 ft-lbs. Zip tie the vent hose to
the brake line if it is within 6” of the
exhaust.
18.
remove the protective covering
from the tailpipe tip.
CAutiON: tHE PrOtECtivE
COvEriNg MAy igNitE AND
BurN iF NOt rEMOvED PriOr tO
ruNNiNg tHE ENgiNE.
19.
Your system includes two (2)
“Banks Power” logos designed to
complement the ford emblems on
the vehicles front fenders. Use the
provided measurements for a clean
factory look (see Figure 10).
20.
re-connect the negative battery
cable. Start the engine and listen for
exhaust leaks. Tighten the exhaust
clamps as necessary. Whenever
possible, tack weld slip connections
to prevent disengagement is
recommended. The Banks Monster
Exhaust installation is now complete.
Figure 9