Banks Power Ford Trucks: (Gas ’04 - 08 F-150 V6 & V8) Exhaust- Monster Exhaust, Dual out the back exit '04-10 F-150 4.2L, 4.6L & 5.4L (Non-Heritage models) - Manual (Page 6)

6
96317 v.5.0
1.
Disconnect the negative (ground)
cable from the battery (if there is more
than one battery, disconnect both
negative cables). Secure the cable so
it cannot accidentally come in contact
with the post.
2.
raise the vehicle and support it
securely with properly weight-rated
safety stands, ramps or a commercial
hoist. Take care to balance the vehicle
to prevent it from slipping or falling.
When using ramps, be sure the wheels
are centered squarely on the topsides.
Place the transmission in park
(automatic), set the parking brake and
securely block the wheels that are on
the ground.
CAutiON: DO NOt wOrk uNDEr
ANy vEHiCLE SuPPOrtED ONLy
By A jACk. SEvErE iNjury MAy
rESuLt.
3.
from under the vehicle remove the
factory exhaust starting at the rear
of the muffler. remove the tailpipe
by removing and retaining the two
(2) M8x1.25 bolts supporting the rear
tailpipe hanger. remove and retain the
rear rubber hanger from the tailpipe
(see Figure 2).
4.
Loosen the factory band clamp
at the front of the muffler. Using
spray lubricant, lube the front and
rear muffler hanger pins. remove the
muffler and tailpipe assembly from the
vehicle (see Figure 3).
NOTE: Removing the rubber hangers
from the vehicle may assist in exhaust
removal.
5.
If applicable, loosen the factory
band clamp on the intermediate
pipe. Using spray lubricant, lube the
intermediate pipe hanger pins and
remove the intermediate pipe from the
vehicle.
6.
FOR SC/MB AND EC/SB MODELS
ONLY, due to the enormous weight
reduction of the Banks Exhaust
Monster Exhaust System installation
FACTORY
TAILPIPE
REAR TAILPIPE
RUBBER HANGER
M8 X 1.25
BOLTS
Figure 2