11 14b – Banks Power Dodge Trucks: (Diesel ’98 - 02 5.9L Cummins ISB) Tuner- Big Hoss Diesel Tuner (does not connect to pump wire) User Manual
Page 11
96766 v.8.0
11
14b.
For 2002 vehicles only, remove
the steering column lower shroud by
removing the 4 torx bolts. Check the
ignition switch to see if it has a 7-pin or
14-pin connector. Refer to Figure 5b
for the 14-pin ignition switch.
If your vehicle has a 7-pin ignition switch,
locate the 10 gauge DARK BLUE wire
at the switch. Trace this wire and
install a YELLOW T-tap at the location
as shown in Figure 5a. Plug the RED
Big Hoss wire into this T-tap. Re-install
the steering column lower shroud.
Proceed to Step 15.
If your vehicle has a 14-pin ignition
switch, locate the 16 gauge DARK
BLUE wire on the switch at Pin #3. See
Figure 5b.
DO NOT use the 10 gauge DARK BLUE
wire. Trace this 16 gauge DARK BLUE
wire and install a RED T-tap at the
location as shown in Figure 5a. Plug
the RED Big Hoss wire into this T-tap.
Re-install the steering column lower
shroud.
15.
Find the small bolt located at
the lower left hand corner as shown
in Figure 6. Remove it and install the
Big Hoss wire ring terminal at this
location. Reinstall the bolt to secure
the ring terminal.
Note: At this point in the installation
process, it is necessary to determine
which model turbocharger your vehicle
is equipped with. A turbocharger
identification tag is located on the
front of the compressor housing of
the turbo or on the actuator. If your
turbocharger is an HY35W, skip to
“Checking engine Performance” on
page 11 and complete Steps 19
through 21 at the end. If the turbo is
not HY35W, continue to Step 16.
Figure 6