Banks Power Dodge Trucks: (Diesel ’98 - 02 5.9L Cummins ISB) Tuner- Big Hoss Diesel Tuner (does not connect to pump wire) - Manual (Page 15)

96766 v.8.0
15
Section 3
BIG HOSS MOUNTING
19.
After confirming the functionality
of the system, make sure all the
mounting surface is clean and free of
dirt and oil before mounting the Big
Hoss. clean and dry as required using
a cloth dampened with rubbing alcohol
or similar cleaning solution.
CAUTION: Do not spray fluid
directly onto any electrical
equipment, or equipment damage
may result.
Mount the Big Hoss Diesel Tuner on
the back of the lower dash panel as
shown in Figure 8 by peeling off the
protective backing off the adhesive
tape on the back of the Big Hoss
Diesel Tuner box.
Note: the Big Hoss Diesel tuner may
not clear the steering structure if it
mounted differently.
20.
Hold the module against the
panel for approximately 1 minute
while applying pressure to allow the
adhesive to properly adhere to the
surface.
21.
Re-install the lower dash panel
with the original 3 bolts. Route all
wiring away from any pedals or other
moving components. Using the cable
ties supplied, secure the wiring under
the dash. Reinstall the trim panel.
Secure all wiring under the hood away
from heat sources or sharp edges.
Your Banks product installation is
complete.
Figure 8