Banks Power Ford Trucks: (Diesel ’03 - 07 6.0L Power Stroke) Tuner- Six-Gun Diesel Tuner w_ optional Speed-Loader Module For use with Six-Gun switch Only - Manual (Page 26)

26
96450 v.9.0
DIAGNOSTIC
CODE
CODE DESCRIPTION COURSE OF ACTION
1,1
Faulty Injection
control Pressure (IcP)
input signal
Check 46-pin connectors. Reset Six-Gun
Diesel Tuner by turning key ON and OFF.
1,2
Faulty Manifold
Absolute Pressure
(MAP) input signal
check MAP sensor connection and 12-pin
Six-Gun Diesel Tuner connector. Reset
Six-Gun Tuner by turning key ON and
OFF.
1,3
Faulty Six-Gun signal
input
Make sure the Six-Gun switch is
connected to the main wire harness.
Reset the Six-Gun Diesel Tuner by turning
the key ON and OFF.
1,4
Faulty barometric
pressure sensor
check barometric T-tap connection
(VIOLET wire). Boost pressure displayed
by the gauges will not be accurate when
changing altitude, but the module will
operate normally.
2,1
Faulty Injection control
Pressure (IcP) output
signal Check the 46-pin Six-Gun Diesel Tuner
connectors. Reset Six-Gun Diesel Tuner
by turning key ON and OFF.
2,2
Faulty Manifold
Absolute Pressure
(MAP) output signal
check MAP sensor connection and 12-pin
Six-Gun Diesel Tuner connector. Reset
Six-Gun Tuner by turning key ON and
OFF.
2,3
Faulty thermocouple
signal check thermocouple ring terminal
connections.
2,4
Tcc stuck (automatic
transmission ONLY)
check Tcc T-tap connection (GRAY wire).
Monitor code occurrence. contact Banks
Technical Service if occurrence becomes
frequent.
3,4
Faulty cAN bus signal
Check 46-pin connectors. Reset Six-Gun
Diesel Tuner by turning key ON and OFF.
Table 1: Banks Six-Gun Diagnostic Codes