Banks Power Ford Trucks: (Diesel ’03 - 07 6.0L Power Stroke) Tuner- Six-Gun Diesel Tuner w_ optional Speed-Loader Module For use with Six-Gun switch Only - Manual (Page 8)

8
96450 v.9.0
1.
Disconnect the battery ground
cables from each of the batteries.
Secure the cables so that they do not
come in contact with the battery posts
during the installation.
2.
Remove the (+) battery cable from
the driver side battery.
3.
Remove the driver side plastic
battery cover, as shown in Figure 1.
This is accomplished by depressing a
tab at the front and rear of the cover.
Be careful not to damage the
cover, as it will be re-installed.
4.
Remove the driver side battery hold
down clamp (8mm socket). Remove
the driver side battery.
WARNING: When lifting a battery,
excessive pressure on the end
walls could cause acid to spew
through the vent caps, resulting
in personal injury. Lift with a
battery carrier or with hands
on opposite corners. Failure to
follow these instructions may
result in personal injury.
5.
Locate the Powertrain control
Module (PcM) on the driver side of the
vehicle engine compartment
(see Figure 2).
6.
Disconnect the middle connector
from the PcM by opening the over-
center retaining clamp as shown in
Figure 2.
2003-04 model year vehicles: Route
the middle connector under the power
steering fluid reservoir.
2005-06 model year vehicles: Route
the middle connector in the most
direct path to the area near the fuse/
relay box.
Plug the connector into the connector
on the Six-Gun module labeled,
“VEHIcLE HARNESS”.
Section 1:
INSTALLATION OF WIRING HARNESS, CONNECTIONS and SIx-GUN
MODULE
Figure 1 Removal of the battery box cover